Specifications

5-27

Cisco 1700 Series Router Software Configuration Guide

78-5407-03

Chapter 5 Configuring ISDN

Dial-Up ISDN Connection with Dialer Profiles

Confirming Connectivity to the Central-Site Router

You can verify your configuration to this point by testing connectivity to the

central-site router, as follows:

Step 1 From the privileged EXEC command mode, enter the ping command, followed by

the IP address of the central-site route to have the router dial the central-site

router. You should see output similar to the following:

Router# ping 192.168.37.40

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.37.40, timeout is 2 seconds:

.!!!!

Success rate is 80 percent (4/5), round-trip min/avg/max = 40/43/48 ms

Router#

*Mar 1 03:37:46.526: %LINK-3-UPDOWN: Interface BRI0:1, changed state

to up

*Mar 1 03:37:46.923: %LINEPROTO-5-UPDOWN: Line protocol on Interface

BRI0:1, changed state to up

*Mar 1 03:37:46.939: %LINK-3-UPDOWN: Interface Virtual-Access1,

changed state to up

*Mar 1 03:37:47.923: %LINEPROTO-5-UPDOWN: Line protocol on Interface

Virtual-Access1, changed state to up

*Mar 1 03:35:57.217: %ISDN-6-CONNECT: Interface BRI0:1 is now

connected to 5552053 HQ

Step 2 Wait for the “ISDN-6-CONNECT” message, as shown in the commmand output

example.

Step 3 Enter the ping command, followed by the IP address of the central-site router

again: