Specifications

5-19
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Chapter 5 Configuring ISDN
Dial-Up ISDN Connection with Dialer Profiles
Verifying Your Configuration
You can verify your configuration to this point by checking the ISDN line status
as follows:
Step 1 From the privileged EXEC command mode, enter the show isdn status
command.
You should see command output similar to the following:
Router# show isdn status
The current ISDN Switchtype = basic-5ess
ISDN BRI0 interface
Layer 1 Status:
ACTIVE
Step4
isdn switch-type basic-ni Configure the type of central office switch
being used on the ISDN interface. Use the
keyword that matches the ISDN switch type
that you are using:
• basic-1tr6—German 1TR6 ISDN
switches
• basic-5ess—Basic rate 5ESS switches
• basic-dms100—NT DMS-100 basic rate
switches
• basic-net3—NET3 ISDN switches
• basic-ni—National ISDN-1 switches
• basic-nwnet3—Norway NET3 switches
(phase 1)
• basic-nznet3—New Zealand NET3
switches
• basic-ts013—Australian TS013 switches
• ntt—Japanese NTT ISDN switches
• vn2—French VN2 ISDN switches
• vn3—French VN3 ISDN switches
Command Task