Specifications

Chapter 5 Configuring ISDN
Dial-Up ISDN Connection to a Central-Site Router
5-14
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
For the second verification procedure, perform these steps:
Step 1 From the privileged EXEC command mode, confirm that the ISDN line is
connected to the remote site by entering the ping command, followed by the IP
address of the central-site router:
Router# ping 192.168.37.40
Step 2 Enter the show interface virtual-access 1 command.
Step 3 Confirm that the “Open: IPCP” message appears in the command output:
Router# show interface virtual-access 1
Virtual-Access1 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 64 Kbit, DLY 100000 usec, rely 255/255, load
1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
DTR is pulsed for 5 seconds on reset
LCP Open, multilink Open
Open: IPCP
Last input 00:00:01, output never, output hang never
Last clearing of "show interface" counters 00:54:41
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
708 packets input, 150742 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
709 packets output, 157653 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Step 4 To continue configuration, reenter global configuration mode.