Specifications

5-11
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Chapter 5 Configuring ISDN
Dial-Up ISDN Connection to a Central-Site Router
Verifying Your Configuration
You can verify your configuration to this point by
• Confirming the Static IP Route
• Confirming the IPX Route
• Confirming Connectivity to the Central-Site Router
• Confirming Multilink PPP Configuration for the B1 Channel
• Confirming Multilink PPP Configuration for the B2 Channel
Confirming the Static IP Route
You can verify your configuration by confirming the static IP route:
Step 1 From the privileged EXEC command mode, enter the show ip route command.
Substitute the
IP address of the central-site router ISDN interface for the IP
address shown in the example.
Step 2 Confirm that the “directly connected via BRI” message (shown in the output
example) appears in the command output:
Router# show ip route 192.168.37.40
Routing entry for 192.168.37.40/32
Known via "connected", distance 0, metric 0 (connected)
Routing Descriptor Blocks:
* directly connected, via BRI0
Route metric is 0, traffic share count is 1
Step 3 To continue configuration, reenter global configuration mode.
Confirming the IPX Route
Step 1 From the privileged EXEC command mode, enter the show ipx route command.
You should see command output similar to the following:
Router# show ipx route 123
Codes: C - Connected primary network, c - Connected secondary
network
S - Static, F - Floating static, L - Local (internal), W -
IPXWAN