Specifications

4-5
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Chapter 4 Configuring Routing Among VLANs with IEEE 802.1Q Encapsulation
Examples of IEEE 802.1Q Encapsulation Configuration
Defining the VLAN Encapsulation Format
To define the encapsulation format as IEEE 802.1Q, use the following commands
in interface configuration mode.
Configuring NetWare on the Subinterface
After you enable NetWare globally and define the VLAN encapsulation format,
you may need to enable the subinterface by specifying the NetWare network
number. Use this command in interface configuration mode.
Examples of IEEE 802.1Q Encapsulation
Configuration
This section provides configuration examples for each of the protocols described
in this chapter:
• Configuring IP Routing over IEEE 802.1Q
• Configuring IPX Routing over IEEE 802.1Q
Command Task
Step1
interface fastethernet
slot/port.subinterface-number
1
1. If the router supports only port numbers, and not slot numbers, the format for this command is
interface fastethernet port.subinterface-number
Specify the subinterface on which
IEEE 802.1Q will be used.
Step2
encapsulation dot1q vlan-identifier
Define the encapsulation format as
IEEE 802.1Q and specify the VLAN
identifier.
Command Task
ipx network network
Specify the IPX network number.