Specifications

9-29
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Chapter 9 Configuring X.25
X.25 over ISDN D Channel
ip 172.16.26.1
ipx 9876.0000.0c03.ecc6
multiprotocol cud pid, standard Tx data PID Window size input: 2,
output: 2
Packet size input: 128, output: 128
PS: 7 PR: 3 ACK: 3 Remote PR: 7 RCNT: 0 RNR: FALSE Retransmits: 0
Timer (secs): 0 Reassembly (bytes): 0 Held Fragments/Packets: 0/0
Bytes 1540/1724 Packets 15/19 Resets 0/0 RNRs 0/0 REJs 0/0 INTs 0/0
Step 2 Look for the following messages in the output:
• “SVC 1”—Means that the X.25 service is active for the X.25 interface.
• “State: D1”—Means that there is an active virtual circuit on the X. 25
interface.
• “Connects 2345 <-->”—Means that the X.25 address is correctly associated
with the IP address and IPX address of the X.25 interface.
• “Packets 15/19”—Means that data is being transferred across the X.25
interface. The number shown in this message varies and indicates the success
rate of data that is being transferred.
Configuring Command-Line Access to the Router
Follow these steps to configure parameters that control access to the router.
Command Task
Step1
line console 0 Specify the console terminal line.
Step2
exec-timeout 5 Set the interval (in minutes) that the EXEC
command interpreter waits until user input is
detected.
Step3
line vty 0 4 Specify a virtual terminal for remote console
access.
Step4
password <lineaccess> Specify a password on the line.
Step5
login Enable password checking at terminal session
login.
Step6
end Exit configuration mode.