Specifications

9-19
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Chapter 9 Configuring X.25
X.25 over ISDN B Channel
Confirming Switched Virtual Circuit and Permanent Virtual Circuit Information
Follow these steps to confirm switched virtual circuit and permanent virtual
circuit information:
Step 1 From the privileged EXEC command mode, enter the show x25 vc command. You
should see command output similar to the following:
Router# show x25 vc
SVC 1, State: D1, Interface: Serial0
Started 00:04:10, last input 00:00:26, output 00:00:33 Connects 2345
<-->
ip 192.168.39.40
ipx 9876.0000.0c03.ecc6
multiprotocol cud pid, standard Tx data PID Window size input: 2,
output: 2
Packet size input: 128, output: 128
PS: 7 PR: 3 ACK: 3 Remote PR: 7 RCNT: 0 RNR: FALSE Retransmits: 0
Timer (secs): 0 Reassembly (bytes): 0 Held Fragments/Packets: 0/0
Bytes 1540/1724 Packets 15/19 Resets 0/0 RNRs 0/0 REJs 0/0 INTs 0/0
Step 2 Confirm that the X.25 network number, shown in the “Connect” message, is
associated with the correct IP and IPX addresses.
Step 3 To continue configuration, reenter global configuration mode.
Configuring Command-Line Access to the Router
Follow these steps to configure parameters that control access to the router.
Command Task
Step1
line console 0 Specify the console terminal line.
Step2
exec-timeout 5 Set the interval that the EXEC command
interpreter waits until user input is detected.
Step3
line vty 0 4 Specify a virtual terminal for remote console
access.
Step4
password <lineaccess> Specify a password on the line.