Specifications

Chapter 9 Configuring X.25
X.25 over ISDN B Channel
9-18
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Note Substitute the IPX address of your central-site router for the IPX
address shown in the example.
Step 3 Confirm that the success rate shown in the output is 60 percent or greater. This
means that your router is successfully transferring data to the central-site router.
Step 4 To continue configuration, reenter global configuration mode.
Confirming That the X.25 Map Is Configured Correctly
Follow these steps to confirm that the X.25 map is configured correctly:
Step 1 From the privileged EXEC command mode, enter the show x25 map command:
Router# show x25 map
Serial0: X.121 2345 <--> ip 192.168.39.40,
ipx 9876.0000.0c03.ecc6
PERMANENT, BROADCAST, 1 VC: 1*
Step 2 Confirm that the following appear in the command output:
• Your router IPX network number
• Central-site router IP address
• Central-site router IPX address
Note The IP and IPX addresses, and your router IPX network number
shown in your output are different than those shown in the example.
Step 3 To continue configuration, reenter global configuration mode.