Specifications

9-17

Cisco 1700 Series Router Software Configuration Guide

78-5407-03

Chapter 9 Configuring X.25

X.25 over ISDN B Channel

Confirming Connectivity with the Central-Site Router over IP

Follow these steps to confirm connectivity with the central-site router over IP:

Step 1 Confirm that your router X.25 connection is active.

Step 2 From the privileged EXEC command mode, enter the ping command, followed by

the IP address of the central-site router. You should see command output similar

to the following:

Router# ping 192.168.39.40

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echo to 192.168.39.40, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 20/20/20

Step 3 Confirm that the success rate shown in the output is 60 percent or greater. This

means that your router is successfully transferring data to the central-site router.

Step 4 To continue configuration, reenter global configuration mode.

Confirming Connectivity to the Central-Site Router over IPX

Follow these steps to confirm connectivity with the central-site router over IPX:

Step 1 Confirm that your router X.25 connection is active.

Step 2 Enter the ping command, followed by the IPX address of the central-site router.

You should see command output similar to the following:

Router# ping 9876.0000.0c03.ecc6

[ip]: ipx

IPX address: 105.0060.834f.667d

Repeat count [5]:

Datagram size [100]:

Timeout in seconds [2]:

Verbose [n]:

Type escape sequence to abort.5, 100-byte IPX cisco Echoes to

9876.0000.0c03.ecc6, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms