Specifications

Chapter 9 Configuring X.25
X.25 over ISDN B Channel
9-16
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Verifying Your Configuration
You can verify your configuration to this point by
• Confirming Connectivity with the Central-Site Router over IP
• Confirming Connectivity to the Central-Site Router over IPX
• Confirming That the X.25 Map Is Configured Correctly
• Confirming Switched Virtual Circuit and Permanent Virtual Circuit
Information
Step9
dialer map ip 192.168.39.40 name HQ
5558461
Configure this interface to place a call to
multiple sites and to authenticate calls from
multiple sites, based on IP address and dialer
string.
The name you enter after the name keyword
in this command must match the name
entered with the username command in the
“Configuring Security” section on
page 9-14.
Step10
dialer map ipx 9876.0000.0c03.e336
name HQ 5558461
Configure this interface to place a call to
multiple sites and to authenticate calls from
multiple sites, based on IP address and dialer
string.
The name you enter after the name keyword
in this command must match the name
entered with the username command in the
“Configuring Security” section on
page 9-14.
Step11
dialer-group 1 Assign this interface to a dialer group.
Step12
dialer-list 1 protocol ip permit Define a dial-on-demand routing (DDR)
dialer list to control dialing based on access
lists and IP packets.
Step13
dialer-list 1 protocol ipx permit Define a DDR dialer list to control dialing
based on access lists and IPX packets.
Command Task