Specifications

9-9

Cisco 1700 Series Router Software Configuration Guide

78-5407-03

Chapter 9 Configuring X.25

X.25

PS: 7 PR: 3 ACK: 3 Remote PR: 7 RCNT: 0 RNR: FALSE Retransmits: 0

Timer (secs): 0 Reassembly (bytes): 0 Held Fragments/Packets: 0/0

Bytes 1540/1724 Packets 15/19 Resets 0/0 RNRs 0/0 REJs 0/0 INTs 0/0

Step 2 Look for the following messages in the output:

• “SVC 1”—Means that the X.25 service is active for the X.25 interface.

• “State: D1”—Means that there is an active virtual circuit on the X. 25

interface.

• “Connects 2345 <-->”—Means that the X.25 address is correctly associated

with the IP address and IPX address of the X.25 interface.

• “Packets 15/19”—Means that data is being transferred across the X.25

interface. The number shown in this message varies and shows the success

rate of data that is being sent.

Step 3 To continue configuration, reenter global configuration mode.

Configuring Command-Line Access to the Router

Follow these steps to configure parameters that control access to the router.

Command Task

Step1

line console 0 Specify the console terminal line.

Step2

exec-timeout 5 Set the interval that the EXEC command

interpreter waits until user input is detected.

Step3

line vty 0 4 Specify a virtual terminal for remote console

access.

Step4

password <lineaccess> Specify a password on the line.

Step5

session login.