Specifications

Chapter 9 Configuring X.25
X.25
9-8
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Step 2 Check that the “line protocol is up” and the “State CONNECT” messages appear
in the command output. If you do not see these messages, see the “X.25 over
ISDN B Channel” section on page 9-10 for suggestions.
Step 3 To continue configuration, reenter global configuration mode.
Confirming That the X.25 Map Is Configured Correctly
Follow these steps to confirm that the X.25 map is configured correctly:
Step 1 From the privileged EXEC command mode, enter the show x25 map command.
You should see command output similar to the following:
Router# show x25 map
Serial0: X.121 2345 <--> ip 172.16.26.2,
ipx 9876.0000.0c03.ecc6
PERMANENT, BROADCAST, 1 VC: 1*
Step 2 Confirm that your IPX network number and the central-site router IP address and
IPX address appear in the command output. The IP and IPX addresses shown in
your output will be different from those shown in the example.
Confirming Switched Virtual Circuit and Permanent Virtual Circuit Information
Follow these steps to confirm the switched virtual circuit and permanent virtual
circuit information:
Step 1 From the privileged EXEC command mode, enter the show x25 vc command, as
follows. You should see command output similar to the following:
Router# show x25 vc
SVC 1, State: D1, Interface: Serial0
Started 00:04:10, last input 00:00:26, output 00:00:33 Connects 2345
<-->
ip 172.16.26.1
ipx 9876.0000.0c03.ecc6
multiprotocol cud pid, standard Tx data PID Window size input: 2,
output: 2
Packet size input: 128, output: 128