Specifications
9-7
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Chapter 9 Configuring X.25
X.25
Step 4 Confirm that the success rate shown in the output is 60 percent or greater. This
means that your router is successfully transferring data to the central-site router.
Step 5 To continue configuration, reenter global configuration mode.
Confirming That the Serial Interface Is Functioning Correctly
Follow these steps to confirm that the serial interface is functioning correctly:
Step 1 From the privileged EXEC command mode, enter the show interface serial0
command. You should see command output similar to the following:
Router# show interface serial0
Serial0 is up, line protocol is up
Hardware is QUICC Serial
Internet address is 172.16.26.1/24
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation X25, loopback not set
x25 DTE, modulo 8, k 7, N1 12056, N2 20
T1 3000, interface outage (partial T3) 0, T4 0 State CONNECT, VS 6, VR
1, Remote VR 6, Retransmissions 0
Queues: U/S frames 0, I frames 0, unack. 0, reTx 0 IFRAMEs 22/25 RNRs
0/0 REJs 0/0 SABM/Es 0/1 FRMRs 0/0 DISCs 0/0 X25 DTE, address 5432,
state R1, modulo 8, timer 0
Defaults: cisco encapsulation, idle 0, nvc 1
input/output window sizes 2/2, packet sizes 128/128 Timers: T10 60,
T11 180, T12 60, T13 60, TH 0 Channels: Incoming-only none, Two-way
1-1024, Outgoing-only none RESTARTs 1/1 CALLs 1+0/2+2/0+0 DIAGs 0/0
Last input 00:00:32, output 00:00:32, output hang never Last clearing
of "show interface" counters never Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input
rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0
packets/sec
40 packets input, 1903 bytes, 0 no buffer Received 0 broadcasts, 0
runts, 0 giants 2 input errors, 0 CRC, 2 frame, 0 overrun, 0 ignored,
0 abort 42 packets output, 2033 bytes, 0 underruns 0 output errors, 0
collisions, 11 interface resets 0 output buffer failures, 0 output
buffers swapped out 7 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up