Specifications

Chapter 9 Configuring X.25

X.25

9-6

Cisco 1700 Series Router Software Configuration Guide

78-5407-03

Step 2 From the privileged EXEC command mode, enter the ping command, followed by

the IP address of the central-site router:

Router# ping 172.16.26.2

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echo to 192.168.39.41, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 20/20/20

Step 3 Confirm that the success rate shown in the output is 60 percent or greater. This

means that your router is successfully transferring data to the central-site router.

Step 4 To continue configuration, reenter global configuration mode.

Confirming Connectivity to the Central-Site Router over IPX

Follow these steps to confirm connectivity to the central-site router over IPX:

Step 1 Confirm that the router is connected to the central-site router.

Step 2 From the privileged EXEC command mode, enter the ping command.

Step 3 Respond to the prompts shown in the following example, entering IPX as the

protocol, and entering the target IPX address.

Note Substitute the IPX address of your central-site router for the IPX

address shown in the example.

Router# ping

Protocol [ip]: ipx

Target IPX address: 9876.0000.0c03.ecc6

Repeat count [5]: <Return>

Datagram size [100]: <<Return>>

Timeout in seconds [2]: <<Return>>

Verbose [n]: <<Return>>

Novell Standard Echo [n]: <<Return>>

Type escape sequence to abort.

Sending 5, 100-byte IPX cisco Echoes to 9876.0000.0c03.ecc6, timeout

is 2 seconds: !!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 20/21/24