Specifications

Chapter 8 Configuring Asynchronous Connections
Asynchronous Dial-Up Connection
8-6
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Step6
dialer in-band Specify that dial-on-demand routing (DDR)
is supported on this interface.
Step7
ipx route 1234 9876.0000.0c06.ecc6 Configure a static route to the central-site
device.
Step8
snapshot client 5 60 Enable snapshot routing. Because your
router is dialing into a central-site router, it
is considered the client router.
The first number is the amount of “active
time” (in minutes) during which routing
updates are exchanged between your router
and the central-site router.
The second number is the amount of “quiet
time” (in minutes) during which routing
entries are frozen and remain unchanged.
Step9
dialer-group 1 Assign the dialer interface to a dialer group.
Step10
encapsulation ppp Set the encapsulation method on this
interface to PPP.
Step11
ppp authentication chap pap callin Enable CHAP or PAP authentication on this
interface. CHAP authentication is attempted
first.
Step12
no shutdown Enable the interface and the configuration
changes that you have just made on the
interface.
Step13
exit Exit configuration mode for this interface.
Step14
line 1 Enter configuration mode for the serial0
interface.
Step15
speed 19200 Configure the baud rate for the asynchronous
line.
Step16
parity n Configure parity on the asynchronous line.
Step17
datab 8 Configure data bits on the asynchronous
line.
Command Task