Specifications

7-47
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Chapter 7 Configuring Frame Relay
ISDN as a Backup Connection with FloatingStaticRoutes
Configuring EIGRP Routing
Follow these steps to configure the router for EIGRP and IP routing parameters
that the router uses to connect to the central-site router.
Step10
dialer idle-timeout 300 Configure the ISDN line to go down after a
specified number of seconds with no network
traffic.
Step11
dialer string 5552053 Configure the telephone number that this
interface dials to reach the central site.
Step12
dialer-group 1 Assign this interface to a dialer group.
Step13
no fair-queue Disable weighted fair queuing for this
interface.
Step14
ppp authentication chap pap Enable CHAP and PAP authentication on this
interface. CHAP authentication is attempted
first. If the central-site router does not support
CHAP, then PAP is used for authentication.
Step15
ppp multilink Enable multilink PPP on this interface.
Step16
no shutdown Enable the interface and the configuration
changes that you have just made on the
interface.
Step17
exit Exit configuration mode for this interface.
Command Task
Command Task
Step1
router eigrp 202 Configure the IP EIGRP routing process.
Step2
network 172.16.0.0 Specify a list of networks for the EIGRP
routing process by entering the IP address of
the directly connected network.
Step3
network 192.168.0.0 To specify a list of networks for the EIGRP
routing process, enter the IP address of the
directly connected network.