Specifications

7-39
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Chapter 7 Configuring Frame Relay
ISDN as a Backup Connection with Dialer Profiles
Configuring Routing Protocols
Follow these steps to configure the router for EIGRP routing.
Configuring Command-Line Access to the Router
Follow these steps to configure parameters that control access to the router.
Step11
no shutdown Enable the configuration changes for this
interface.
Step12
exit Exit configuration mode for this subinterface.
Command Task
Command Task
Step1
router eigrp 1 Configure the router for IP EIGRP routing.
Step2
network 172.16.0.0 Configure the IP network address for EIGRP
routing.
Step3
exit Exit router configuration mode.
Command Task
Step1
line console 0 Specify the console terminal line.
Step2
exec-timeout 5 Set the interval (in minutes) that the EXEC
command interpreter waits until user input is
detected.
Step3
line vty 0 4 Specify a virtual terminal for remote console
access.
Step4
password <lineaccess> Specify a password on the line.
Step5
login Enable password checking at terminal session
login.
Step6
end Exit configuration mode.