Specifications

7-17
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Chapter 7 Configuring Frame Relay
Frame Relay with an Internal DSU/CSU
Configuring Routing Parameters
Follow these steps to configure the Frame Relay interface for EIGRP routing.
Step5
ip address 192.168.38.41 255.255.255.0 Configure this interface with an IP address
and a subnet mask.
Step6
ipx network 456 Enable IPX routing on this interface.
Step7
snapshot client 5 60 Enable snapshot routing. Because your router
is dialing into a central-site router, it is
considered the client router.
The first number is the amount of “active
time” (in minutes) during which routing
updates are exchanged between your router
and the central-site router.
The second number is the amount of “quiet
time” (in minutes) during which routing
entries are frozen and remain unchanged.
Step8
frame-relay interface-dlci 17 Assign a DLCI to the Frame Relay
subinterface.
Step9
no shutdown Enable the interface and the configuration
changes that you have just made on the
interface.
Step10
exit Exit configuration mode for the serial
interface.
Command Task
Command Task
Step1
router eigrp 202 Configure the IP EIGRP routing process.
Step2
network 172.16.0.0 To specify a list of networks for the EIGRP
routing process, enter the IP address of the
directly connected network.