Specifications

Chapter 7 Configuring Frame Relay
Frame Relay
7-10
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Step 2 Note the percentage in the “Success rate” line, as shown in the example. If the
success rate is 60 percent or greater, this verification step is successful.
Step 3 To continue configuration, reenter global configuration mode.
Configuring Routing Parameters
Follow these steps to configure the Frame Relay interface for Enhanced Interior
Gateway Routing Protocol (EIGRP) routing.
Configuring Command-Line Access to the Router
Follow these steps to configure parameters that control access to the router.
Command Task
Step1
router eigrp 202 Configure the IP EIGRP routing process.
Step2
network 172.16.0.0 To specify a list of networks for the EIGRP
routing process, enter the IP address of the
directly connected network.
Step3
ip classless Configure the router to forward packets
addressed to a subnet of a network with no
network default route.
Step4
exit Exit router configuration mode.
Command Task
Step1
line console 0 Specify the console terminal line.
Step2
exec-timeout 5 Set the interval in minutes that the EXEC
command interpreter waits until user input is
detected.
Step3
line vty 0 4 Specify a virtual terminal for remote console
access.
Step4
password <lineaccess> Specify a password on the line.