Specifications

7-3
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Chapter 7 Configuring Frame Relay
Frame Relay
Figure 7-1 Configuration Example—Frame Relay
Configuring Global Parameters
Follow these steps to configure the router for global parameters.
Frame Relay
14320
Remote site
Central site
Serial subinterface 1
IP address: 192.168.39.41
1700
Router
IPX network: 987
Ethernet IPX network: ABC
Command Task
Step1
configure terminal Enter configuration mode.
Step2
service timestamps debug datetime msec Configure the router to show the date and time
of all debug messages.
This command is optional, but it is
recommended if you use debug commands to
troubleshoot your configuration.
Step3
service timestamps log datetime msec Configure the router to show the date and time
of all log messages.
This command is optional, but it is
recommended if you use the verification steps
described in this guide. This feature is
enabled for all the command output examples
shown in this guide.
Step4
ipx routing 0060.834f.66dd Enable Internetwork Packet Exchange (IPX)
routing, and configure the router with an IPX
address.