Specifications

Chapter 6 Configuring a Leased Line
Before You Begin
6-2
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Note To use the verification steps described in this chapter, you must be familiar
with Cisco IOS commands and command modes. When you use the
verification steps, you need to change to different command modes. If you are
not familiar with command modes, see the “Understanding Command Modes”
section in the “Introduction to Router Configuration” chapter.
These are the major tasks in configuring the router:
• Configuring Global Parameters
• Configuring Security
• Configuring the Fast Ethernet Interface
• Configuring the Serial Interface
• Configuring Dynamic Routing Parameters
• Configuring Command-Line Access to the Router
Figure 6-1 shows the configuration example used in this chapter.
Figure 6-1 Configuration Example for Leased Line
Cisco
1700
Cisco
1700
Leased line
IPX network: AAAA
Network address:
IP:10.0.0.0
IPX:100
Network address:
IP:20.0.0.0
IPX:200
Remote site
Central site
Ethernet interface
IP address:
10.1.1.1
14486