Installation guide

Installing a WAN or Voice Interface Card in a Network Module or Chassis Slot
Cisco WAN Interface Cards Hardware Installation Guide
2-8
The following warning applies to routers that use a DC power supply:
Figure 2-3 Cisco 2600 Series WAN Interface Card Chassis Slot Locations
Figure 2-4 Installing a Serial WAN Interface Card in a Two-Slot Network Module
Warning
After wiring the DC power supply, remove the tape from the circuit breaker
switch handle and reinstate power by moving the handle of the circuit breaker to the ON
position.
SEE MANUAL BEFORE INSTALLATION
SERIAL 1
SERIAL 0
CONN CONN
WIC
2A/S
SEE MANUAL BEFORE INSTALLATION
SERIAL 1
SERIAL 0
CONN CONN
WIC
2T
Cisco 2612
100-240V– 1A
50/60 Hz 47 W
W0
AUX
CONSOLE
ETHERNET 0
ACT
LINKACTTOKEN RING 1LINK
W1
Network
module
slot
10344
WAN interface
card slot W1
WAN interface
card slot W0
1-port serial
WAN interface card
2-slot network module
2E
2W
W1
ETH 1
ETH 0
AUI
EN
ACT
LNK
ACT
LNK
WO
H7533
SERIAL