Installation guide

Installing a Network Module in a Cisco 3600 Series or Cisco 2600 Series Router
Cisco WAN Interface Cards Hardware Installation Guide
2-4
Figure 2-1 Installing a Network Module in a Modular Router (typical)
Step 4
Push the module into place until the edge connector is securely seated in the
connector on the motherboard. Ensure that each of the module’s captive screws
lines up with its corresponding hole in the chassis.
Step 5 Secure the captive mounting screws into the holes of the chassis using a Phillips
or flat-blade screwdriver.
Network Module Filler Panels
If you are installing a network module in a Cisco 3600 series router, and the router is not
fully configured with modules, you must fill the open slots with slot filler panels (see
Figure 2-2) to ensure proper airflow.
Module
Router
H7481
INPUT 100-240VAC 50/60HZ 3.0-1.5 AMPS
2E
2W
W1
ETHERNET 1 ETHERNET 0
EN
AUI
WO
ACT
LNK
ACT
LNK
ACT
SERIAL
BRI
NT1
B1
B2
NT1
2
0
3
1
SEE MANUAL BEFORE INSTALLATION
2E
2W
W1
AUI
EN
ACT
LNK
ACT
LNK
WO
BRI
S/T
B1
B2
DO NOT INSTALL WAN INTERFACE
CARDS WITH POWER APPLIED
ETHERNET 1
ETHERNET 0