Installation guide

Overview of Cisco WAN and Voice Interface Cards 1-25

Call Progress Tone Settings

VIC-2FXO voice interface cards are available in several versions with interfaces intended

for different geographical regions.

There are no hardware settings for connecting these voice interface cards to the public

switched telephone network. To comply with national regulatory requirements, you must

set call progress tones to the values shown in Table 1-7, using the Cisco IOS cptone

command.

To set call progress tones for a voice port, enter the following commands in global

conﬁguration mode:

Router(config)# voice-port

slot-number/subunit-number/port

Router(config-voice-port)# cptone

setting

Table 1-7 Call Progress Tone Settings

Country Setting Compliance

Australia australia ACA TS 002/TS 003

Canada northamerica Industry Canada CS-03

Denmark dk –

Germany de BAPT 223 ZV 5:July 1996

Great Britain gb PD 7020:1996

Hong Kong hk HK Telecom CR01 and CR02

Luxembourg lu –

Mexico northamerica NOM-036-SCT1-1993

Sweden se SS 63 63 39

Switzerland ch BAKOM 337/2.2

Thailand th PTT Subscriber Line Standards

United States northamerica FCC Part 68