Technical data

Overview of Tasks
Dial Solutions Quick Configuration Guide
4-2
Note To enhance readability throughout this chapter, the most important output fields are
highlighted with bold font. The commands you enter are also bold but are preceded by a router
prompt.
Overview of Tasks
Perform the following steps:
• “Step 1—Configuring System Level Settings” on page 2
• “Step 2—Configuring the LAN Profile” on page 5
• “Step 3—Configuring the Site Profile hq-sanjose” on page 7
• “Step 4—Testing Connections to the Cisco AS5300” on page 9
• “Step 5—Confirming the Final Running Configuration” on page 11
Note Before you perform the configuration tasks in this chapter, be sure you understand the overall
software configuration action plan. See the chapter “Dial Case Study Overview.”
Step 1—Configuring System Level Settings
System level settings include system name, security, ISDN setup, and PPP setup.
Configure
To configure the system level settings, use the following commands in system mode:
Step Command Purpose
1
> set system soho-tahoe
Enter the host name for this Cisco 766.
2
soho-tahoe> set switch ni1
Specify the ISDN switch type that your phone company
uses.
3
soho-tahoe> set 1 directorynumber 5558084
soho-tahoe> set 2 directorynumber 5558085
Enter the directory numbers for the BRI port’s two
B channels.
4
soho-tahoe> set 1 spid 53055580840101
soho-tahoe> set 2 spid 53055580850101
Configure your SPIDs, which are required by many
switches types. The SPID number is a derivative of the
directory number.
5
soho-tahoe> set phone[phone]
soho-tahoe> set phone[phone]
Enable calls to route to the phone 1 and phone 2 POTS
jacks.
6
soho-tahoe> set voicepriority out conditional
soho-tahoe> set voicepriority in conditional
Set the incoming and outgoing voice priority mode.
It determines whether the system will disconnect a B
channel assigned to a data call to allow a voice call.
7
soho-tahoe> set ppp multilink on
Turn on multilink PPP.
8
soho-tahoe> set ppp authentication incoming chap
Authenticate incoming callers using CHAP.
9
soho-tahoe> set ppp secret host
Enter new password: tahoe-pw
Re-Type new password: tahoe-pw
Specify the CHAP password for authenticating PPP
peers. You must enter it twice for verification
1
.