Technical data

xvii
Getting Help
Router(config-controller)# cas-group ?
<0-23> Channel number
Router(config-controller)# cas-group
Enter the command that you want to
configure for the controller. In this
example, the cas-group command is used.
Enter a ? to display what you must enter
next on the command line. In this example,
you must enter a channel number from 0
to 23.
Because a <cr> is not displayed, it indicates
that you must enter more keywords to
complete the command.
Router(config-controller)# cas-group 1 ?
timeslots List of timeslots in the cas-group
Router(config-controller)# cas-group 1
After you enter the channel number, enter a
? to display what you must enter next on
the command line. In this example, you
must enter the timeslots keyword.
Because a <cr> is not displayed, it indicates
that you must enter more keywords to
complete the command.
Router(config-controller)# cas-group 1 timeslots ?
<1-24> List of timeslots which comprise the cas-group
Router(config-controller)# cas-group 1 timeslots
After you enter the timeslots keyword,
enter a ? to display what you must enter
next on the command line. In this example,
you must enter a list of timeslots from 1 to
24.
You can specify timeslot ranges (for
example, 1-24), individual timeslots
separated by commas (for example 1, 3, 5),
or a combination of the two (for example
1-3, 8, 17-24). The 16th time slot is not
specified in the command line, because it is
reserved for transmitting the channel
signaling.
Because a <cr> is not displayed, it indicates
that you must enter more keywords to
complete the command.
Router(config-controller)# cas-group 1 timeslots 1-24 ?
service Specify the type of service
type Specify the type of signaling
Router(config-controller)# cas-group 1 timeslots 1-24
After you enter the timeslot ranges, enter a
? to display what you must enter next on
the command line. In this example, you
must enter the service or type keyword.
Because a <cr> is not displayed, it indicates
that you must enter more keywords to
complete the command.
Router(config-controller)# cas-group 1 timeslots 1-24 type ?
e&m-fgb E & M Type II FGB
e&m-fgd E & M Type IIFGD
e&m-immediate-start E & M Immediate Start
fxs-ground-start FXS Ground Start
fxs-loop-start FXS Loop Start
sas-ground-start SAS Ground Start
sas-loop-start SAS Loop Start
Router(config-controller)# cas-group 1 timeslots 1-24 type
In this example, the type keyword is
entered. After you enter the type keyword,
enter a ? to display what you must enter
next on the command line. In this example,
you must enter one of the signaling types.
Because a <cr> is not displayed, it indicates
that you must enter more keywords to
complete the command.
Table 1 How to Find Command Options (Continued)
Command Comment