Technical data

Cisco AS5300 Configuration 2-31
Step 10—Testing Async PPP Connections
Step 10—Testing Async PPP Connections
Now you are ready to send the first async PPP modem call into the Cisco AS5300. This step provides
you with a picture of the test lab followed by debug output for a successful connection.
Figure 2-3 shows the test lab environment used for this test. A test PC makes a PPP
modem-to-modem connection with the Cisco AS5300 via the PSTN/ISDN network.
Figure 2-4 Test Lab Environment
Step 1
Enter the following debugging commands on the Cisco AS5300:
hq-sanjose# debug ppp negotiation
PPP protocol negotiation debugging is on
hq-sanjose# debug ppp authentication
PPP authentication debugging is on
hq-sanjose# debug modem
Modem control/process activation debugging is on
hq-sanjose# debug ip peer
IP peer address activity debugging is on
hq-sanjose# show debug
General OS:
Modem control/process activation debugging is on
Generic IP:
IP peer address activity debugging is on
PPP:
PPP authentication debugging is on
PPP protocol negotiation debugging is on
hq-sanjose# terminal monitor
RS-232
Test PC
RS-232
console
Cisco AS5300
receiving call
from test PC
Administrator's PC
(configuration and logging)
Step 1
Enter debug
commands
Step 3
Interpret debug
messages
Step 2
Call atdt5551234
using the terminal
emultion program
POTS
15990
PRI
555-1234
PSTN/ISDN
Modem