Technical data

Step 7—Testing Async Shell Connections
Dial Solutions Quick Configuration Guide
2-24
• Enter the show modem log 1/1 command to view the information logged for
modem 1/1. The time stamps show when the event occurred. The most current events
begin at the bottom of the output.
hq-sanjose# show modem log 1/1
Modem 1/1 Events Log:
20:40:45: Startup Response: Microcom (Managed)
Modem (boot) firmware = 2.2(8) (1.0(5))
---- snip ----
00:02:19: ISDN incoming calling number: 5551111
00:02:19: ISDN incoming called number: 5551234
00:02:13: Modem State event: Dialing/Answering
00:02:13: Modem State event: Incoming ring
00:02:13: Modem State event: Waiting for Carrier
00:02:13: RS232 event: RTS DTR CTS DSR noDCD noRI* noTST
00:02:01: Modem State event: Connected
00:02:01: Connection event: TX/RX Speed = 33600/33600, Modulation = V34
Direction = Answer, Protocol = reliable/LAPM, Compression = V42bis
00:02:02: RS232 event: RTS DTR CTS DSR DCD* noRI noTST
00:01:50: Modem Analog signal event: TX = -21, RX = -18, Signal to noise = 43
00:00:15: DTR event: DTR Off
00:00:15: Modem State event: Connected
00:00:15: End connection event: Retransmits for EC block (TX/RX) = 0/0
Duration = 0:01:43, Number of TX/RX char = 159/0
Local Disc Reason = DTR Drop
Remote Disc Reason = Unknown
00:00:15: Modem State event: Disconnecting
00:00:15: DTR event: DTR On
00:00:15: RS232 event: RTS DTR* CTS* DSR* noDCD* noRI* noTST*
• Enter the show modem command. In the following example, the current active call is
on modem 1/1, which is functioning properly at 100%. An active call is indicated by
an asterisk (*).
hq-sanjose# show modem
Inc calls Out calls Busied Failed No Succ
Mdm Usage Succ Fail Succ Fail Out Dial Answer Pct.
1/0 0% 0 0 0 0 0 0 0 0%
* 1/1 0% 1 0 0 0 0 0 0 100%
1/2 0% 0 0 0 0 0 0 0 0%
1/3 0% 0 0 0 0 0 0 0 0%
1/4 0% 0 0 0 0 0 0 0 0%
1/5 0% 0 0 0 0 0 0 0 0%
1/6 0% 0 0 0 0 0 0 0 0%
1/7 0% 0 0 0 0 0 0 0 0%
1/8 0% 0 0 0 0 0 0 0 0%
1/9 0% 0 0 0 0 0 0 0 0%
1/10 0% 0 0 0 0 0 0 0 0%
1/11 0% 0 0 0 0 0 0 0 0%
---- snip -----