Technical data

Cisco AS5300 Configuration 2-23
Step 7—Testing Async Shell Connections
Step 4 To determine the status of the modem call connected to the Cisco AS5300, use the
following modem management commands.
• Enter the show user command to see which TTY line the call landed on:
hq-sanjose# show user
Line User Host(s) Idle Location
* 0 con 0 joe-admin idle 0
2 tty 2 joe-admin Async interface 1
• Enter the show line 2 command. Note that TTY 2 is associated with modem 1/1.
The state is currently idle because this command was entered after the user
disconnected.
hq-sanjose# show line 2
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns
2 TTY 115200/115200 - inout - - - 0 0 0/0
Line 2, Location: "", Type: ""
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 115200/115200, no parity, 1 stopbits, 8 databits
Status: No Exit Banner
Capabilities: Hardware Flowcontrol In, Hardware Flowcontrol Out
Modem Callout, Modem RI is CD
Modem state: Idle
modem(slot/port)=1/1, state=IDLE
dsx1(slot/unit/channel)=NONE, status=VDEV_STATUS_UNLOCKED
Group codes: 0
Modem hardware state: CTS noDSR DTR RTS
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
00:10:00 never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns
not set
Modem type is unknown.
Session limit is not set.
Time since activation: never
Editing is enabled.
History is enabled, history size is 10.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed transports are lat pad telnet rlogin v120. Preferred is lat.
No output characters are padded
No special data dispatching characters
Called Party
Number
Identifies the called phone number that is used to reach another device.
In this case study,
5551234 is the directory number assigned to the Cisco AS5300. The test
PC dialed this number to make a modem connection.
Table 2-3 Information Elements within an ISDN Setup Message (Continued)
Message Description