Technical data
Site Profile Characteristics
Dial Solutions Quick Configuration Guide
2-2
Table 2-1 provides detailed information about each end of the connection. This is the network
administrator’s top-level design table.
Cisco IOS Release 12.0 is running inside the access server. If the startup configuration is blank,
the following screen is displayed at bootup. The automatic setup script is engaged. Enter no when
you are asked the question, “Would you like to enter the initial configuration dialog? [yes]: no.”
In this case study, the Cisco AS5300 is manually configured using the Cisco IOS software.
The automatic setup script is not used.
Note To enhance readability throughout this chapter, the most important output fields are
highlighted with bold font. The commands you enter are also bold but are preceded by a router
prompt.
Copyright (c) 1994-1995 by cisco Systems, Inc.
AS5300 processor with 32768 Kbytes of main memory
program load complete, entry point: 0x80008000, size: 0xf4b10
Self decompressing the image : #################################################
################################################################################
################################################################################
################################################################################
################################################################################
################## [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Table 2-1 Site Characteristics
Site
Hardware
WAN
IP Address
Ethernet
IP Address
Assigned Phone
Number
Host Name/
Username
1
Username
Password
1
1. Make sure to use your own host names and passwords. For example soho-tahoe and tahoe-pw are for this case study’s purpose only.
Cisco
AS5300
2
2. The subnet 10.1.2.0 255.255.255.0 is used for the loopback interface and the local IP address pools.
10.1.254.1
255.255.255.0
3
3. This address is configured on the Cisco AS5300’s dialer interface.
10.1.1.10
255.255.255.0
4085551234
4
4. This is the PRI telephone number assigned to the central site (hq-sanjose). This number is often called the hunt group number, which
distributes calls among the available B channels. All four PRI trunks on the Cisco AS5300 should be assigned to this number by the
PRI provider.
hq-sanjose hq-sanjose-pw
Cisco 766 10.1.254.3
255.255.255.0
10.1.3.1
255.255.255.0
Directory number =
5305558084
soho-tahoe tahoe-pw
Cisco 1604 10.1.254.4
255.255.255.0
10.1.4.1
255.255.255.0
Directory number =
5125554433
robo-austin austin-pw