Technical data

Cisco 766 Configuration 4-11
Step 5—Confirming the Final Running Configuration
Troubleshooting and Debugging Tips
• Sometimes calls fail because the public phone network is blocking the call, which is beyond your
control. Look at the B channel LEDs on the router. If the CH1 light is flashing, it means that the
router is trying to place a call. Be patient and wait for the call to go through.
• If problems persist, have the local administrator connect to the command line interface (CLI) of
the Cisco700 using telnet or a directly attached console to use various show commands, as
described in the next bullet.
• Use log commands to enhance the output to the CLI. For example, the log calls verbose
command displays call information on the terminal screen. If calls connect (channel LED on
steady) then quickly disconnect, plus you are having serious connection problems, turn on PPP
debugging by entering the diag ppp on | off command. Be sure to set diag ppp off when the
function is not in use by an administrator.
Step 5—Confirming the Final Running Configuration
Here is the final configuration running on the Cisco 766. This configuration file can be used as a basic
template for turning up additional remote sites. The bold entries are site specific. They should be
customized for each site.
Timesaver You can save time configuring a Cisco 766 by pasting a configuration file directly into a router.
To do this, first return the router to its default state using the set default command. The router has no running
configuration after this command is entered. Next, paste in the configuration file.
set system soho-tahoe
set switch ni1
set 1 spid 53055580840101
set 2 spid 53055580850101
set 1 directorynumber 5558084
set 2 directorynumber 5558085
set phone[phone]
set phone[phone]
set voice out conditional
set voice in conditional
set ppp multilink on
set ppp authentication incoming chap
set ppp secret host
tahoe-pw
tahoe-pw
set password system
admin-pw
admin-pw
cd lan
set ip address 10.1.3.1
set ip netmask 255.255.255.0
set ip routing on
set ip rip update off
set bridging off
cd
set user hq-sanjose
set prof power=activate user=hq-sanjose
cd hq-sanjose
set active
set encap ppp
set ip routing on
set ip framing none
set ip address 10.1.254.3
12
6
93