Technical data

Cisco 766 Configuration 4-9
Step 4—Testing Connections to the Cisco AS5300
Ringback Number
CLI Validate Number
CLICallback OFF
CLIAuthentication OFF
Step 4—Testing Connections to the Cisco AS5300
This section describes how to perform the test. Figure 4-2 shows the actual test lab environment used
in this test case.
Figure 4-2 Test Lab Environment
Step 1
Look at the routing table. Enter the show ip route command to verify that the correct
routes are set up. Before you try to use IP, you should verify that IP will work.
View this information in the hq-sanjose profile and at the system level. If the profile is
shut down, you will not see the route at the system level.
soho-tahoe:hq-sanjose> show ip route
Profile Type Destination Bits Gateway Prop Cost Source Age
------------------------------------------------------------------------------
hq-sanjose NET 10.1.254.0 24 DIRECT ON 1 DIRECT 0
soho-tahoe:hq-sanjose> cd
soho-tahoe> show ip route
Profile Type Destination Bits Gateway Prop Cost Source Age
------------------------------------------------------------------------------
LAN NET 10.1.3.0 24 DIRECT ON 1 DIRECT 0
hq-sanjose NET 10.1.254.0 24 DIRECT ON 1 DIRECT 0
PSTN/ISDN
15989
Cisco AS5300
(hq-sanjose)
BRI
BRI
Ethernet
Cisco 766
(soho-tahoe)
RS-232
console
Administrator's PC
(configuration and logging)
10.1.254.3
10.1.254.1
DNS server
10.2.2.3