Technical data
Step 3—Configuring the Site Profile hq-sanjose
Dial Solutions Quick Configuration Guide
4-8
Verify
To verify the configuration:
• Enter the show security command to view the security parameters associated with the hq-sanjose
profile. Notice that the Cisco 766 is not configured to support PAP.
soho-tahoe:hq-sanjose> show security
Profile Parameters
PPP Security
PPP Authentication OUT NONE<*>
PPP Authentication ACCEPT EITHER
Token Authentication Support
TAS Mode OFF
TAS Client 0.0.0.0
Use Local CHAP Secret ON
Client
User Name soho-tahoe
PAP Password NONE
CHAP Secret EXISTS
Host
PAP Password NONE
CHAP Secret EXISTS
Callback
Request OFF
Reply OFF
• Enter the show configuration command to view the configuration settings for the hq-sanjose
profile. Notice that bridging is turned off and IP routing is on. The dialed number for each
channel is displayed. Hq-sanjose’s phone number is 4085551234.
soho-tahoe:hq-sanjose> show configuration
Profile Parameters
Bridging Parameters
Bridging OFF<*>
Routed Protocols IP <*>
Learn Mode ON
Passthru OFF
Call Startup Parameters
Line Parameters
Line Speed AUTO
Numbering Plan NORMAL
Call Parameters Link 1 Link 2
Auto ON ON
Called Number 14085551234<*> 14085551234<*>
Backup Number
15
soho-tahoe:hq-sanjose> set ppp secret client
soho-tahoe:hq-sanjose> Enter new Password: tahoe-pw
soho-tahoe:hq-sanjose> Re-Type new Password: tahoe-pw
Specify the secret password to use when
soho-tahoe is logging into hq-sanjose
4
.
1. On Cisco IOS devices the PPP name is defined by one of the following commands: hostname, sgbp group, ppp pap sent-username, or ppp chap hostname.
2. By definition IP address 10.1.254.1 is connected to the Cisco 766’s BRI interface, because the dialer’s subnet contains address 10.1.254.1.
3. You are less likely to run into a problem by using 56K. After the connection is up and operational, try to upgrade the speed to 64K. Call blocking is more common
at 64K than 56K. During the experiment, check to see if you have any reliability issues. The set speed auto command tells the router to try 64K. However, only
a 64K end-to-end data path will work. If you are blocked, try again at 56K.
4. This secret client password must match the password configured on hq-sanjose. For example, the password “tahoe-pw” is in the central site’s username
soho-tahoe password tahoe-pw command. See the section “Configuring Site Definitions” in the chapter “Cisco AS5300 Configuration.”
Step Command Purpose