Installation guide

2-20
Cisco ONS 15530 Hardware Installation Guide
OL-7706-01
Chapter 2 Installing the Cisco ONS 15530
Installing and Removing Line Cards or Motherboards
Figure 2-15 Releasing the SFP
Step 5
Pull the SFP out and place it in a container appropriate for shipping and storage. (See Figure 2-16.)
Figure 2-16 Removing the SFP
Tip In an unlikely event of the pull-tab is damaged or missing, use a screwdriver to push on the hinge pin to
unlock the SFP cage latch and pull the SFP out from SFP port
Note SFPs with RJ-45 connectors require cabling after it is installed, and removal of cables is required before
removing the SFP from the card.
Removing Non-Pull Tab SFPs with RJ-45 Connectors
To remove an SFP with an RJ-45 connector from the muxponder, follow these steps:
Step 1 Remove the cable from the desired SFP.
Step 2 Pull the latch on the SFP out. This releases the SFP from the latch lock of the cage.
Step 3 Pull the SFP out and place it in a container appropriate for shipping and storage.
120369
120370