Installation guide

1-35
Cisco ONS 15530 Hardware Installation Guide
OL-7706-01
Chapter 1 Cisco ONS 15530 Overview
Cisco ONS 15530 Components
The 8-port multi-service muxponder uses SFPs for the client signals. There are no restrictions on
populating the line card with SFPs. For example, you can mix a single-mode SFP with a multimode SFP
on the same card. Table 1-19 lists the characteristics for the SFPs supported by the 8-port multi-service
muxponder.
Table 1-18 8-Port Multi-Service Muxponder LEDs
LED Status Description
Status Off No power to the muxponder.
Red The functional image on the trunk is not configured.
Yellow The system clock is not present.
Blinking green The muxponder is out of reset, and the system clock is good
and waiting for software initialization.
Green The muxponder is initialized and operational.
Client port status Rx green Port is operational.
Rx off Rx link is down.
Tx green Transmit enabled.
Tx off Transmit disabled.
Trunk status East green The muxponder is communicating with the West signal.
West green The muxponder is communicating with the East signal.
Rx green Light reception exists at the port.
Txgreen Transmit enabled.
Table 1-19 8-Port Multi-Service Muxponder SFP Characteristics
Part Number
Protocols or Clock Rate
Range Supported Fiber Type Wavelength
Connector
Type
15500-XVRA-10A2 Low band 8 Mbps to
200 Mbps
MM 50/125 µm
MM 62.5/125 µm
1310 nm LC
15500-XVRA-10B2 Low band 8 Mbps to
200 Mbps
SM 9/125 µm 1310 nm LC
15500-XVRA-11A2 Mid-band 200 Mbps to
622 Mbps
MM 62.5/125 µm 1310 nm LC
15500-XVRA-11B2 Mid-band 200 Mbps to
1.25 Gbps
SM 9/125 µm 1310 nm LC
15500-XVRA-12B1 High-band 1.062 Gbps to
2.488 Gbps
SM 9/125 µm 1310 nm LC
15454-SFP-GEFC-SX Fibre Channel (2.125 Gbps),
Fibre Channel (1 Gbps),
Gigabit Ethernet
MM 50/125 µm
MM 62.5/125 µm
850 nm LC
15500-XVRA-08D1 T1
1
1.544 Mbps Copper T1 – RJ-45
15500-XVRA-09D1 E1 2.044 Mbps Copper E1 – RJ-45