Installation guide

1-32
Cisco ONS 15530 Hardware Installation Guide
OL-7706-01
Chapter 1 Cisco ONS 15530 Overview
Cisco ONS 15530 Components
The Cisco ONS 15530 supports up to four 8-port FC/GE aggregation cards for a total of 32 client
signals.
Table 1-16 describes the LEDs on the 8-port FC/GE aggregation card.
The 8-port FC/GE aggregation card uses single-mode and multimode SFP optics for the client signals.
There are no restrictions on populating the line card with SFPs. For example, you can mix a single-mode
SFP optics with a multimode SFP optics on the same port pair. Table 1-17 lists the characteristics for the
SFP optics supported by the 8-port FC/GE aggregation card.
Note The SFP optics must be purchased separately.
Protocol monitoring is the same as for single mode transponder modules and multimode transponder
modules.
Table 1-16 8-Port FC/GE Aggregation Card LEDs
LED Status Description
STATUS Off No power to the board.
Red Card is in reset or the LRC is not configured.
Yellow Card is out of reset.
Green Card is properly initialized.
TX Green Port is up and transmit laser is enabled.
RX Green Light reception exists at the port.
Table 1-17 8-port FC/GE Aggregation Card SFP Optics Characteristics
Part Number
Protocols or Clock Rate Range
Supported Fiber Type Wavelength
Connector
Typ e
15500-XVRA-02C1 Gigabit Ethernet
1
, Fibre Channel
(1 Gbps)
2
, FICON (1 Gbps)
1. 1000BASE-SX
2. FC-0-100-M5-SN-S and FC-0-100-M6-SN-S standards
MM 50/125 µm
MM 62.5/125 µm
850 nm LC
15500-XVRA-03B1 Gigabit Ethernet
3
, Fibre Channel
(1 Gbps)
4
, FICON (1 Gbps),
ISC-3 links compatibility mode,
ISC peer mode
3. 1000BASE-LX
4. FC-0-100-SM-LC-S standard
SM 9/125 µm 1310 nm LC
15500-XVRA-11B1 Mid-band variable rate
200 Mbps to 1.25 Gbps
SM 9/125 µm 1310 nm LC
15500-XVRA-11B2 Mid-band variable rate
200 Mbps to 1.25 Gbps
SM 9/125 µm 1310 nm LC
15500-XVRA-12B1 High-band variable rate
1.062 Gbps to 2.488 Gbps
SM 9/125 µm 1310 nm LC