Installation guide

1-29
Cisco ONS 15530 Hardware Installation Guide
OL-7706-01
Chapter 1 Cisco ONS 15530 Overview
Cisco ONS 15530 Components
Table 1-14 lists the LEDs on the 4-port 1-Gbps/2-Gbps FC aggregation card, their default conditions,
and what the conditions indicate.
The 4-port 1-Gbps/2-Gbps FC aggregation card uses single-mode and multimode SFP optics for the
client signals. There are no restrictions on populating the line card with SFPs. Table 1-15 lists the
characteristics for the SFP optics supported by the 4-port 1-Gbps/2-Gbps FC aggregation card.
Table 1-14 4-Port 1-Gbps/2-Gbps FC Aggregation Card LEDs
LED Status Description
STATUS Off No power to the board.
Red Card is in reset or the LRC is not configured.
Yellow Card is out of reset.
Green Card is properly initialized.
TX Green Port is up and transmit laser is enabled.
RX Green Light reception exists at the port.
Table 1-15 4-port 1-Gbps/2-Gbps FC Aggregation Card SFP Optics Characteristics
Part Number
Protocols or Clock Rate
Range Supported Fiber Type Wavelength
Connector
Type
15500-XVRA-02C1 Gigabit Ethernet
1
, Fibre
Channel (1 Gbps)
2
, FICON
(1 Gbps), ISC-1 (1-Gbps)
1. 1000BASE-SX
2. FC-0-100-M5-SN-S and FC-0-100-M6-SN-S standards
MM 50/125 µm
MM 62.5/125 µm
850 nm LC
15500-XVRA-03B1 Gigabit Ethernet
3
, Fibre
Channel (1 Gbps)
4
, FICON
(1 Gbps), ISC-3 links
compatibility mode
SM 9/125 µm 1310 nm LC
15500-XVRA-03B2 Fibre Channel (1-Gbps and
2-Gbps), FICON (1-Gbps
and 2 Gbps)
SM 9/125 µm 1310 nm LC
15500-XVRA-11B1 Mid-band variable rate
200-Mbps to 1.25-Gbps,
ISC-1
SM 9/125 µm 1310 nm LC
15500-XVRA-12B1 High-band variable rate
1.062-Gbps to 2.488-Gbps,
ISC-1, ISC-3
SM 9/125 µm 1310 nm LC
15454-SFP-GEFC-SX Fibre Channel (2-Gbps),
Fibre Channel (1-Gbps),
FICON (1-Gbps and 2 Gbps)
ISC-3 (1-Gbps and 2 Gbps)
MM 50/125 µm
MM 62.5/125 µm
850 nm LC
ONS-SE-GEFC-SX Fibre Channel (2-Gbps),
Fibre Channel (1-Gbps),
FICON (1-Gbps and 2 Gbps)
ISC-3 (1-Gbps and 2 Gbps)
MM 50/125 µm
MM 62.5/125 µm
850 nm LC