Installation guide

A-12
Cisco ONS 15530 Hardware Installation Guide
OL-7706-01
Appendix A Specifications
8-Port Multi-Service Muxponder Specifications
8-Port Multi-Service Muxponder Specifications
Table A-18 lists the 8-port multi-service muxponder receiver and transmitter specifications. Optical loss
because of splitter modules and connectors should be included in the optical budget calculation.
Note The optical specifications described in this section are only for the individual components and should
not be used to characterize the entire network performance.
The SFPs supported on the 8-port multi-service muxponder are shown in Table A-19. The optical power
characteristics and other specifications of the supported SFPs are listed in the “SFP Specifications”
section on page A-16. Only use Cisco-certified SFPs for the 8-port multi-service muxponder.
Note The optical specifications described in this section are only for the individual components and should
not be used to characterize the entire network performance.
3. FC = Fibre Channel
4. FICON = Fiber Connection
5. ITU = International Telecommunication Union
Table A-18 8-Port Multi-Service Muxponder ITU Trunk Specifications
Description
Specification
Fiber type G.652 (SMF-25)
Connector MU–PC
Receiver sensitivity OSNR
1
,
2
1. OSNR = optical signal-to-noise ratio.
2. Add the proper network-level penalty to the OSNR and/or receive power based on your actual
network topology characteristics, such as dispersion.
Dispersion
–26 dBm 20 dB ±1000 ps/nm
3
3. ps/nm = picoseconds per nanometer.
–24 dBm 21 dB 1000 to 2100 ps/nm
–23 dBm 2 dB 2100 to 3200 ps/nm
Receiver Minimum Maximum
Overload –8 dBm
Wavelength 1260 nm 1580 nm
Transmitter Minimum Maximum
Transmitter power 5 dBm 10 dBm