Installation guide

A-9
Cisco ONS 15530 Hardware Installation Guide
OL-7706-01
Appendix A Specifications
4-Port 1-Gbps/2-Gbps FC Aggregation Card
4-Port 1-Gbps/2-Gbps FC Aggregation Card
The 4-port 1-Gbps/2-Gbps FC aggregation cards support the SFPs listed in Table A-13. The optical
power characteristics of the supported SFPs are listed in the SFP Specifications section. Only use
Cisco-certified SFPs for the 4-port 1-Gbps/2-Gbps FC aggregation cards. If the specifications of the
client equipment interfaces do not fall within these ranges, attenuators or amplifiers might be required.
Note The optical specifications described in this section are only for the individual components and should
not be used to characterize the entire network performance.
Table A-12 Latency for ESCON Aggregation Cards
Traffic Mix on
Transmitting Node
Maximum Added End-to-End Latency
1
1. The latency values are based on configuration of correct transmit buffer sizes as described in the Cisco ONS 15530
Configuration Guide.
No GE
1518-Byte
GE Packets
4470-Byte
GE Packets
10,230-Byte
GE Packets
ESCON only 8.5 µs
ESCON and
FC/FICON on the
same 10-Gbps ITU
trunk card
8.5 µs
ESCON and GE only
on the same 10-Gbps
ITU trunk card
10 µs 12.5 µs 17 µs
Table A-13 SFPs Supported by the 4-port 1-Gbps/2-Gbps FC Aggregation Card
Part Number Protocols or Clock Rate Range Supported
15500-XVRA-02C1 Gigabit Ethernet
1
, Fibre Channel (1 Gbps)
2
, FICON (1 Gbps)
1. 1000BASE-SX
2. FC-0-100-M5-SN-S and FC-0-100-M6-SN-S standards
15500-XVRA-03B1 Gigabit Ethernet
3
, Fibre Channel (1 Gbps)
4
, FICON (1 Gbps), ISC-3 links
compatibility mode
3. 1000BASE-LX
4. FC-0-100-SM-LC-S standard
15500-XVRA-03B2 Fibre Channel (1 Gbps and 2 Gbps), FICON (1 Gbps and 2 Gbps)
15500-XVRA-11B1 Mid-band variable rate 200 Mbps to 1.25 Gbps
15500-XVRA-12B1 High-band variable rate 1.062 Gbps to 2.488 Gbps
15454-SFP-GEFC-SX Fibre Channel (2 Gbps), Fibre Channel (1 Gbps), Gigabit Ethernet, FICON
(1 Gbps and 2 Gbps)