Installation guide

3-11
Cisco ONS 15530 Hardware Installation Guide
OL-7706-01
Chapter 3 Connecting the Cisco ONS 15530
Connecting the CPU Switch Module
Step 2 Run the cable up and through the cable management bracket (not supplied) and connect the other end of
the RJ-45 crossover cable to the RJ-45 adapter (see Figure 3-8). If your terminal is equipped with one
of the following:
• DB-25 serial connector, use the RJ-45-to-DB-25 adapter.
• DB-9 serial connector, use the RJ-45-to-DB-9 adapter.
Figure 3-8 Connecting an RJ-45-to-DB-9 Console Cable Adapter
Step 3
Connect the adapter to your video terminal to complete the cable connection.
Step 4 Power on your video terminal.
Step 5 Configure your video terminal to match the following default console port settings:
• 9600 baud
• 8 data bits
• No parity generation or checking
• 1 stop bit
• No flow control
Auxiliary Modem Connection
This asynchronous EIA/TIA-232 serial port connects a modem to the CPU switch module for remote
administrative access.
30028