Installation guide

3-8

Cisco ONS 15530 Hardware Installation Guide

OL-7706-01

Chapter 3 Connecting the Cisco ONS 15530

Connecting the CPU Switch Module

To connect the CPU switch module to a 100BASE-T Ethernet LAN, follow these steps:

Step 1 Connect one end of the Ethernet cable to the RJ-45 port on the primary CPU switch module, labeled

NME (see Figure 3-6).

Figure 3-6 Connecting 100BASE-T to Ethernet Port

Step 2

Run the cable up and through the cable management bracket and connect the other end of the Ethernet

cable to any unoccupied port on the Ethernet hub.

Step 3 Check the LINK LED on the CPU switch module (below the NME port).

This LED is green if the CPU switch module is correctly connected to the 100BASE-T Ethernet LAN.

STATUS

RESET

ACTIVE

STANDBY

COMPACT

FLASH

CIRTICAL

MAJOR

AUX

NME

FDX

100MBPS

LINK

CON

CUTOFF

HIST

CLR

CUTOFF

MINOR

15530-CPU

79119