Datasheet

C-46
Cisco ONS 15454 SDH Reference Manual, R7.0
October 2008
Appendix C Network Element Defaults
C.3 Node Default Settings
C.3 Node Default Settings
Table C-16 on page C-47 lists the node-level default settings for the Cisco ONS 15454 SDH. Cisco
provides the following user-configurable defaults for each Cisco ONS 15454 SDH node:
• Circuit settings—Set the administrative state, subnetwork connection protection (SNCP) circuit
threshold levels for signal degradation and failure, SNCP reversion time, and whether SNCP circuits
are revertive by default.
• General settings—Set general node management defaults, including whether to use Daylight
Savings Time (DST), the IP address of the NTP/SNTP server to be used, the time zone where the
node is located, the SD path BER value, and the defaults description.
• Power Monitor settings—Set default voltage thresholds for the node.
• Network settings—Set whether to prevent display of node IP addresses in CTC (applicable for all
users except Superusers); default gateway node type; whether to raise an alarm when the backplane
LAN cable is disconnected; and whether to display the IP address in the LCD in an editable mode
(in which you can change the IP address directly from LCD screen), to display the IP address on the
LCD as read-only, or to suppress display of the IP on the LCD entirely.
• OSI settings—Set Open System Interconnection (OSI) main setup, generic routing encapsulation
(GRE) tunnel, link access protocol on the D channel (LAP-D), router subnet, and TID address
resolution protocol (TARP) settings.
• Linear Multiplex Section Protection (LMSP) settings—Set whether or not protected circuits have
bidirectional switching, are revertive, and what the reversion time is.
• MS-SPRing protection settings—Set whether MS-SPRing-protected circuits are revertive, and what
the reversion time is, at both the ring and span levels.
• Legal Disclaimer—Set the legal disclaimer that warns users at the login screen about the possible
legal or contractual ramifications of accessing equipment, systems, or networks without
authorization.
• Security Grant Permissions—Set default user security levels for activating/reverting software,
performance monitoring data clearing, database restoring, and retrieving audit logs.
• Security DataComm settings—Set default security settings for TCC Ethernet IP address and IP
netmask, and CTC backplane IP suppression; set secure mode on and secure mode locked (for
TCC2P cards only).
FC-MR.config.port.enhancedFibreChannelFicon.IngressIdleFiltering TRUE TRUE, FALSE
FC-MR.config.port.enhancedFibreChannelFicon.MaxFrameSize 2148 2148, 2152, 2156, 2160, 2164,
2168, 2172
FC-MR.config.port.MediaType Undefined Fibre Channel - 1 Gbps ISL,
Fibre Channel - 2 Gbps ISL,
FICON - 1 Gbps ISL, FICON - 2
Gbps ISL, Undefined
FC-MR.config.port.State locked,
disabled
unlocked, locked, disabled,
locked, maintenance, unlocked,
automaticInService
Table C-15 FC_MR-4 Card Default Settings (continued)
Default Name Default Value Default Domain