Datasheet

15-35
Cisco ONS 15454 SDH Reference Manual, R7.0
October 2008
Chapter 15 Performance Monitoring
15.7.2 STM-1E Card Performance Monitoring Parameters
Figure 15-10 PM Read Points on the STM-1E Cards in E4 Mode
The PM parameters for the STM-1E cards are listed in Table 15-17. The parameters are defined in
Table 15-3 on page 15-5.
110403
ONS 15454 SDH
STM-1E Card in E4 Mode
Pointer Processors
OCEAN
ASIC
Cross-Connect
Card STM-1E
Path
Level
in
E4 Mode
ES
ESR
SES
SESR
BBE
BBER
UAS
EB
PMs read on OCEAN ASIC
Table 15-17 PM Parameters for the STM-1E Cards
RS (NE) MS (NE/FE) PJC (NE)
1, 2
1. In CTC, the count fields for PPJC and NPJC PM parameters appear white and blank unless they are enabled on the
Provisioning > OC3 Line tabs. See the “15.3 Pointer Justification Count Performance Monitoring” section on page 15-4.
2. For information about troubleshooting SNCP switch counts, refer to the “Alarm Troubleshooting” chapter in the
Cisco ONS 15454 SDH Troubleshooting Guide.
VC4 and VC4-Xc
HP Path (NE)
3
3. SDH path PM parameters do not increment unless IPPM is enabled. See the “15.2 Intermediate-Path Performance
Monitoring” section on page 15-3.
VC4 and VC4-Xc Path
for E4 Mode (NE)
RS-BBE
RS-BBER
RS-EB
RS-ES
RS-ESR
RS-SES
RS-SESR
UAS-SR
MS-BBE
MS-BBER
MS-EB
MS-ES
MS-ESR
MS-SES
MS-SESR
HP-PPJC-Pdet
HP-NPJC-Pdet
HP-PPJC-Pgen
HP-NPJC-Pgen
HP-BBER
HP-BBER
HP-EB
HP-ES
HP-ESR
HP-SES
HP-SESR
HP-UAS
BBE
BBER
EB
ES
ESR
SES
SESR
UAS