Datasheet

xxxvii
Cisco ONS 15454 SDH Reference Manual, R7.0
October 2008
About this Manual
Table 1 Cisco ONS 15454 SDH Reference Manual Chapters
Title Summary
Chapter 1, “Shelf and FMEC Hardware” Includes descriptions of the rack, ferrites, power
and ground, fan-tray assembly, air filter, card slots,
cable, cable connectors, and cable routing.
Chapter 2, “Common Control Cards” Includes descriptions of the TCC2P, XC10G,
XC-VXL, and AIC-I cards.
Chapter 3, “Electrical Cards” Includes descriptions of E1-N-14, E1-42, E3-12,
DS3i-N-12, STM1E-12, FMEC cards, MIC cards,
card temperature ranges, and compatibility.
Chapter 4, “Optical Cards” Includes descriptions of the STM1-4, STM1-8,
STM-4, STM4-4, STM-16, STM-64, TXP_MR,
TXPP_MR, and MXP cards, as well as card
temperature ranges and card compatibility.
Chapter 5, “Ethernet Cards” Includes descriptions of the E100T-G, E1000-2-G,
G1000-4, G1K-4, CE-100T-8, ML100T-12,
ML1000-2, and ML100X-8 cards, gigabit interface
converters (GBICs) and small form-factor
pluggables (SFPs).
Chapter 6, “Storage Access Networking Cards” Includes the FC_MR-4 card description and
application.
Chapter 7, “Card Protection” Includes electrical, optical, and transponder and
muxponder card protection methods, as well as
external switching commands.
Chapter 8, “Cisco Transport Controller
Operation”
Includes information about CTC delivery,
installation, computer requirements, connection,
the CTC window, and database reset and revert.
Chapter 9, “Security” Includes user set up, security parameters and
profiles, audit trail information, and RADIUS
authentication information.
Chapter 10, “Timing” Includes node and network timing information.
Chapter 11, “Circuits and Tunnels” Includes descriptions of circuit properties,
cross-connect card bandwidth usage, data
communications channel (DCC) and
IP-encapsulated tunnels, multiple destination
circuits, circuit monitoring, subnetwork
connection protection (SNCP) and multiplex
section-shared protection rings (MS-SPRing)
circuits, J1 path trace, path signal labels, manual
and automatic circuit routing, and virtual
concatenated (VCAT) circuits.
Chapter 12, “SDH Topologies and Upgrades” Includes the SDH configurations used by the
ONS 15454 SDH; including MS-SPRings, SNCPs,
subtending rings, linear ADMs, and optical bus
configurations, as well as information about
upgrading optical speeds within any configuration.