Datasheet

3-33
Cisco ONS 15454 SDH Reference Manual, R7.0
October 2008
Chapter 3 Electrical Cards
3.18 MIC-C/T/P FMEC
3.18 MIC-C/T/P FMEC
Note For MIC-C/T/P FMEC specifications, see the “A.5.17 MIC-C/T/P Specifications” section on
page A-27.
The MIC-C/T/P FMEC provides connection for the BATTERY A input, one of the two possible
redundant power supply inputs. It also provides connection for system management serial port, system
management LAN port, modem port (for future use), and system timing inputs and outputs. Install the
MIC-C/T/P in Slot 24. Figure 3-19 shows the MIC-C/T/P faceplate and block diagram.
43 ALMOUP2 P Normally open output pair 3 Green/white
44 ALMOUP3 N Normally open output pair 4 White/brown
45 ALMOUP3 P Normally open output pair 4 Brown/white
46 AUDALM0 N Normally open Minor audible alarm White/gray
47 AUDALM0 P Normally open Minor audible alarm Gray/white
48 AUDALM1 N Normally open Major audible alarm Red/blue
49 AUDALM1 P Normally open Major audible alarm Blue/red
50 AUDALM2 N Normally open Critical audible alarm Red/orange
51 AUDALM2 P Normally open Critical audible alarm Orange/red
52 GND Frame ground —
53 AUDALM3 N Normally open Remote audible alarm Red/green
54 AUDALM3 P Normally open Remote audible alarm Green/red
55 VISALM0 N Normally open Minor visual alarm Red/brown
56 VISALM0 P Normally open Minor visual alarm Brown/red
57 VISALM1 N Normally open Major visual alarm Red/gray
58 VISALM1 P Normally open Major visual alarm Gray/red
59 VISALM2 N Normally open Critical visual alarm Black/blue
60 VISALM2 P Normally open Critical visual alarm Blue/black
61 VISALM3 N Normally open Remote visual alarm Black/orange
62 VISALM3 P Normally open Remote visual alarm Orange/black
Table 3-16 Alarm Interface Pinouts on the MIC-A/P DB-62 Connector (continued)
Pin No. Signal Name Signal Description Color