Troubleshooting guide

32
Release Notes for Cisco ONS 15454 Release 7.0.2
OL-11368-01
New Features and Functionality
Bridge and Roll
CSCei37364
When a rollTo leg is not receiving a good signal, and because of this the rollPending alarm is not cleared,
there is no alarm indicating the reason that the RollPending alarm fails to clear. This issue is resolved in
Release 7.0.
TL1
CSCsc62784
The Calibration Tilt is not properly changed using the TL1 interface. The reference tilt is changed
instead. This issue can be seen when you try to change the CALTILT parameter on amplifier cards using
the ED-OTS command. To avoid this issue, use CTC. This issue is resolved in Release 7.0.1.
New Features and Functionality
This section highlights new features and functionality for Release 7.0.x. For detailed documentation of
each of these features, consult the user documentation.
New Features for Release 7.0.2
The following feature has been added for Release 7.0.2.
Daylight Savings Time Support
With Release 7.0.2 CTC and TL1 display daylight savings time (DST) in keeping with the new DST rules
applicable from 2007 forward. As described in the change in energy policy for the United States of
America (USA), the DST start date will be the 2nd Sunday of March and the DST end date will be 1st
Sunday of November.
The following features were added for Release 7.0.
New Hardware
MXP_MR_10DME-C and MXP_MR_10DME-L Multirate Muxponder Cards
The 10-Gbps Multirate Muxponder-100 GHz-Tunable 15xx.xx-15yy.yy C-band and L-band
(MXP_MR_10DME-C and MXP_MR_10DME-L) cards aggregate a mix of client Storage Area
Network (SAN) service client inputs (GE, FICON, and Fibre Channel) into one 10-Gbps
STM-64/OC-192 DWDM signal on the trunk side. They provide one long-reach STM-64/OC-192 port
per card and are compliant with Telcordia GR-253-CORE and ITU-T G.957.
The cards support aggregation of the following signal types: