Troubleshooting guide

Release Notes for Cisco ONS 15454 Release 7.0.2

OL-11368-01

Resolved Caveats for Release 7.0.x

• Cost: 10

• Provision any non-DCN connected node as ENE.

A documented solution is available in the February 2006 online version of the ONS 15454 DWDM

Reference Manual, Release 7.0.

SNMP Attribute Changes

The following SNMP attributes will be replaced in future releases, and will no longer be supported after

Release 7.0.

• cMsDwdmIfMultiplexSectionRingDirection

• cMsDwdmIfTransportRingDirection

• cMsDwdmIfChannelRingDirection

TL1

Note To be compatible with TL1 and DNS, all nodes must have valid names. Node names should contain

alphanumeric characters or hyphens, but no special characters or spaces.

CSCsb72582

You cannot perform an ENT-EQPT for a valid card type when the current equipment state is

OOS-AUMA,MEA&UAS. When the fault PPM comes up as OOS-AUMA,MEA&UAS and then the

ENT-EQPT command is entered using TL1, the command is rejected. This issue will be resolved in a

future release.

CSCsc41650

Using a TL1 script to rapidly preprovision/delete various cards repeatedly in the same slot will reboot

the TCC approximately 1 out of 10 times. Put a delay of about 10 seconds between

preprovisioning/deletion cycles and the node will not reboot. This issue will be resolved in a future

release.

CSCdu53509

When a TL1 session to a remote node (ENE) is established via a gateway node (GNE) and you have

changed the node name of the ENE via either TL1, CTC or SNMP, then you must wait for about 30

seconds to issue a TL1 command via the GNE. This delay is to permit the updates to propagate to all

nodes in the network. During this transition, neither the old node name nor the new node name can be

used in the TL1 session to access the ENE. This 30 second window may be reduced in a future release.

Resolved Caveats for Release 7.0.x

This section documents caveats resolved in Release 7.0.x.