Specifications

5-25
Cisco ONS 15216 EDFA Operation Guide
78-12818-01
Chapter 5 Command Line Reference
Maintenance Commands
Example 5-22 SRESET Command:
0-0>SRESET
LD 1: Temp Compensated
LD 2: Temp Compensated
Caution Only use this command if the EDFA has entered an inconsistent state.
After bootup, the current control mode of the EDFA is broadcast. In Example 5-22, the EDFA has the
temperature-compensated constant gain mode as the default mode of operation.
Note Alarms are not valid during the booting period (12 seconds). This command does not affect service.
!SETADDR
Explanation:
An exclamation point placed at the beginning of the SETADDR command overrides the logon
requirement of the EDFA. This allows a new address to be assigned without knowledge of the EDFA's
current address. After the confirmation prompt is returned, the user is logged out. In practice, the
exclamation point shown in the following example is not echoed back (Example 5-23).
Example 5-23 !SETADDR Command:
!SETADDR xy
x-y>
Use Table 5-16 to interpret and issue the !SETADDR command.
Command: !SETADDR
Syntax: !SETADDR xx, where xx is decimal number
Password: N/A
Configuration: Yes
Brief Description: Bootstraps the EDFA address
Table 5-16 EDFA Address Parameters
Parameter Format Description
x 0-9 First half of EDFA address
y 0-9 Second half of EDFA address