Specifications

5-14
Cisco ONS 15216 EDFA Operation Guide
78-12818-01
Chapter 5 Command Line Reference
System Commands
Pump 1 Pump 2
Name Type Crnt Cnt Crnt Cnt Descr
LCRNT Minor OK 0 OK 0 Excessive pump crnt/pump bias
LTMP Minor OK 0 OK 0 LD temp out-of-range
EDFA 1
Name Type Crnt Cnt Descr
LPOUT Major Dsbl 0 Loss outp pwr
LPIN Major Dsbl 0 Loss inp pwr
GAIN Major Dsbl 0 Gain out-of-range
CTMP Major OK 1 Case temp out-of-range
0-0>
CONFIG
Explanation:
Configuration data consists of the control mode for each laser, all alarm enable/disable states, and loss
of input threshold. After reset, the EDFA will use the saved configuration as the starting point for EDFA
control.
As shown in Figure 5-1, entering the CONFIG S command followed by the letter Y saves the
configuration. If you enter CONFIG S followed by the letter N, the save operation will be cancelled.
Command: CONFIG
Syntax: CONFIG S
Password: Yes
Configuration: Yes
Brief Description: Saves the current EDFA configuration