Specifications

5-3
Cisco ONS 15216 EDFA Operation Guide
78-12818-01
Chapter 5 Command Line Reference
User Commands
User Commands
Each command in this chapter is described in the following format:
If you need additional information about a specific command or its syntax, enter the command followed
by a question mark (?).
The following example displays the HELP command screen. See the“HELP” section on page 5-7 for
more specific information.
Example 5-1 HELP Command:
0-0>HELP
System Status System Commands Setup Commands Maintenance
------------------------------------------------------------------------
ALARM ALMDSBL SET_LOSTH CUTOVER
HELP ALMENBL SETGT LOAD
LD CONFIG SETI SETADDR
PRM LOGOUT SETOUT SRESET
STAT PASS SETP
VER
------------------------------------------------------------------------
Enter 'Command ?' for syntax
0-0>
Measurement Parameters
The format for measurement parameters is as follows:
% [width].[precision]type,
Additional parameters include:
• Width-total field width
• Precision-number of decimals
Command: Command Name
Syntax:
Help information associated with a given command is
displayed by issuing COMMAND ?
Password: Password protection status
Configuration:
Command affects configuration data; the data must be saved
using the CONFIG command to retain it through a reset,
power down, or cutover operation
Brief
Description:
Simple description of command
Explanation:
Demonstration, relevant parameters, parsing rules, and
warnings